AR7 Charging Handle

The Haga Defense Charging Handle for the AR7 was designed to make operating the rifle MUCH easier than with the factory handle which can be hard to pick/pull out and grip.

• Machined from 7075 Aluminum
• Hardcoat Anodized
• Weight 0.3 oz
• Easy to install
• Can still be stored in factory stock
• Made in USA

All handles have rack marks from the anodizing process. These will not be visible when installed or affect performance.

Installation: When the rifle is disassembled simply press the bolt in about 1/16" with your finger. This will allow the charging handle to be pulled straight out the side of the receiver. Installation is just as easy. Press in on the bolt slightly until the bolt hole lines up with the hole on the receiver then insert the new charging handle.

Storage: The rifle and charging handle can still be stored inside the factory stock if done like pictured below.