CP33 Extended Handguard

MP7 inspired Handguard for the CP33 is designed to give your CP33 that MP7 front end look while adding MLOK mounting options and additional top rail space. 

This handguard is designed to be used with a suppressor or muzzle extension. DO NOT fire your CP33 without using either of these while the handguard is installed. Failure to do so could result in injury or damage to the handguard and/or installed accessories. For muzzle extensions CLICK HERE.

• Fits suppressors up to 1.1" in diameter (pictured with TS AXIOM 1")
• Built-in Hand Stop/Barricade Stop
• Weight 1.5oz
• Made in the USA

This part is manufactured from Nylon using a process called Multi Jet Fusion or MJF. The parts are then sandblasted, dyed and shotpeened for a strength and finish that is comparable to injection molded nylon. The part is black throughout.

Warning: Be careful when installing MLOK accessories. Clearance is tight and using improperly sized hardware could damage the handguard or an installed suppressor. Two short #10-24 screws have been included. These can be used in place of longer screws on many popular MLOK accessories. 

Other MP7 Clone Parts for your CP33 (not included)
MP7 Style Vertical Grip - CLICK HERE
MP7 Style "Stock" - coming soon
MP7 Style Magazine Extension - coming soon

Installation: 

1. BEFORE STARTING, MAKE SURE THE WEAPON IS UNLOADED, THE CHAMBER IS EMPTY, AND THE SAFETY IS ENGAGED.
2. Remove the factory MLOK bottom cover and the two screws holding it in place. The foreword screw threads into a captive nut. Be sure to leave that nut in place. 
3. Slide the new handguard onto the receiver from front to back until it mates up with the trigger guard. 
4. Secure in place using the two included screws. The shorter screw goes in the front and the longer to the rear of the handguard. These only need to be hand tightened with the included hex wrench (5 in-lbs or so). If the front screw doesnt seem to be threading in be sure that the factory mounting nut hasn't fallen out of place.