CMR-30 Barrel Shroud (Mock Suppressor)

Product Description

The Haga Defense Barrel Shroud (Mock Suppressor) for the Kel-Tec CMR-30 gives a suppressed appearance while serving as a barrel shroud, covering approximately 6" of exposed barrel. The built-in muzzle device extends 1" past the barrel end for a total length of about 7". Machined from 7075 aluminum with a hardcoat anodize finish, this lightweight accessory threads on easily for a clean, tactical look.

Specifications

• Material: 7075 aluminum
• Finish: Mil-A-8625 Type III Class 2 hardcoat anodize, black
• Thread: 1/2-28
• Rear Opening Diameter: 0.6"
• Muzzle Opening Diameter: 0.24"
• Weight: 5.7 oz
• Total Length: Approximately 7"
• Made in: USA

Compatibility and Installation Notes

• Compatible with Kel-Tec CMR-30 (1/2-28 threaded barrel)
• May fit other firearms with 1/2-28 threads
• Simple threaded installation—remove factory thread protector and thread on shroud
• Ensure fully threaded and tightly mounted before firing (failure to do so could result in damage)
• No permanent modifications required

Installation Instructions

1. Safety First: Before beginning installation, make sure the firearm is completely unloaded, the chamber is empty, and the safety is engaged. Remove the magazine, visually and physically inspect the chamber to confirm it is empty, and point the firearm in a safe direction at all times.
2. Remove the factory thread protector from the barrel muzzle.
3. Thread the shroud onto the barrel (1/2-28 threads) until fully seated and tight.
4. Verify the shroud is securely mounted before firing—failure to do so could result in damage to the part.